Frequent use puts much strain on even the highest-quality commercial garage doors. When a door starts to fail, troubleshooting can be very time-consuming.
Fortunately, there are some common commercial garage door repairs you can do yourself to get your overhead system functioning again. These simple maintenance tasks can save you time and money in the long run.
Broken Springs
Garage door springs can break for several reasons, including normal wear and tear. Generally, a quality spring is engineered to support about 10,000 cycles – one cycle being the garage door opening and closing.
When that happens, you’ll need to replace it. This can be an expensive and time-consuming project.
It is also hazardous to do if you don’t have the proper tools and safety precautions. Calling a professional to help you repair your springs is always best.
Fortunately, there are a few things you can do yourself to help ensure that your springs last as long as possible. These include keeping them well lubricated and avoiding exposure to rust. Rust increases friction and decreases a spring’s effectiveness.
Dirty Rollers
Dirty rollers can be one of the biggest problems regarding commercial garage door repair. This is because these rollers are in charge of guiding your garage door to open and close.
To clean your rollers, wipe them off regularly with a lint-free cloth dipped in distilled water. This will help remove any dirt or grime that built up over time.
Keeping your rollers clean can also prevent pi lines from developing on your film. These are caused by dirt that has been deposited on the metal rollers inside of your camera.
Cleaning your rollers is easy and can be done at home. You can use a flashlight, a strong cotton towel or WD-40 or your favorite roller rejuvenator to get them cleaned and rejuvenated.
Damaged Panels
When your commercial garage door panel has been damaged, you may need to repair or replace it. Damaged panels can cause your door to sag, which is a safety concern. It can also make your entry more susceptible to break-ins, leading to the misalignment of tracks that keep your garage from opening or closing correctly.
You can repair your damaged panel by heating and cooling it. This can help get rid of the dent and make it straight again.
However, it’s important to note that this method is only effective for minor dents. If the dent is more significant, you’ll likely need to replace the panel.
Professionals in commercial garage door repair also use some newer methods to fix garage door panels. One involves using suction tools to remove the dent from a metallic board.
Damaged Sections
If one or more sections of your commercial garage door are dented, cracked, or otherwise damaged, they should be repaired immediately. This is because the panels may be unable to align properly with the track and can cause severe problems with operation.
Damaged sections can also be a safety and security hazard, putting anyone in your building at risk. This is especially true for parts under high tension, like cables and springs.
Torsion springs are a standard part of most commercial garage doors that help counterbalance the weight and keep the doors in place while opening and closing. They’re rated to last around 10,000 cycles but can become worn down quickly by impacts and other factors.
Bent or broken tracks are another common problem that can cause problems with opening and closing doors. A professional technician for commercial garage door repair can straighten or replace the tracks to get your doors functioning correctly again.